The stone arrived in perfect condition. I like the size as it does not take up much room on the counter. The one used professionally was very large and heavy. I have not put and edge on my knives for over 5 years. A whetstone is a luxury I could only afford recently. Given how dull they were it did not take long to put a nice sharp edge on them. What a joy to use a well care for tool again. The grit size was perfect too. One to put an edge on the knives and the other to finish and remove burrs[sp]
Now it's time to polish. This is when you'll swap over from the coarse grit to the finer grit (make sure this side is wet, too). I found the knife still had a bit of grime on it, so I gave it a wipe clean beforehand. The motion is exactly the same as with sharpening, but you can apply slightly less pressure, and limit to roughly 30 strokes on each side.
Heres why I wasn't impressed at first. I only used it for a few minutes on each side, which resulted in nothing. I watched a video online with a master chef using his stone, and he sharpened his knife for 10 minutes on each stone before moving up to a finer grit. I took this hint, and used sharpened my knife on each side of this stone for 10 minutes, which led to perfection.
You might not need to spend hundreds of pounds to get the best knife sharpener, but you do need to know what you're doing. Warner gave me a crash course in the technique. As a newbie to this method, it took a while to get used to (especially since Warner handed me a knife that had never previously been sharpened) but after half an hour's practice and a little encouragement, I got the hang of it. Here's what I learned...
We regret that due to technical challenges caused by new regulations in Europe, we can for the time being no longer accept orders from the European Union. If you reside in the UK you can continue to order from our UK websites or shop from our locations and partners. Visit West Elm at www.westelm.co.uk and Pottery Barn Kids at www.potterybarnkids.co.uk.
Ceramic whetstones are meant to be used without water or oil, which means they can be used almost anywhere and are ideal for chefs or cooks who have limited working spaces. They will give you a very sharp blade and as their surface is very hard they will maintain their flat surfaces over the long-term, but as they have a fine grit, they can break if you drop the stone.
It is believed that Vikings suspended these knife sharpening tools from their belt. However, it is not exactly clear, even to scholars, how the Vikings wore these pendants. We laced ours with a versatile, adjustable high-quality leather cord and packed it in a USA-made muslin pouch so you get to choose how to wear it or carry it. Wear it around the neck for the most Ragnariest looking necklace you’ve ever seen, cinch it all the way down so that it can be hitched to your belt or clipped onto your pack, or simply pocket it while still contained in the hand-stamped muslin pouch.
The more you use the sharpening stone; the edges of each particle within the stone tend to become slightly rounded over time. When you notice that it is taking much longer to hone blades and edges, it means you need to replace the stone with a new one. Sharpening stones come with decks that make it convenient to keep the tool in balance on the stone.
TO USE: Soak stone in water for no more than 5-10 minutes. Place stone on a damp cloth with the courser 400 grit side (dark green) facing up. Hold the knife so that it’s flat and perpendicular to the block, with the blade facing left. Holding the knife at a 20-degree angle, slowly sweep the edge of the blade from left to right down the length of the stone and continue until sharp. If stone starts to feel too dry, add more water. Be patient and take your time. Flip knife over and repeat on the other side (now moving from right to left). Be sure to sharpen both sides evenly. To polish the blade further, flip stone over to the fine 1000 grit side (light green) and repeat the process. When blade is honed to desired sharpness, wash and dry your knife. To clean your stone, simply rinse with water, wipe away any remaining metal residue with a rag, rinse again, then dry.