To sharpen a knife using a whetstone, submerge the stone in water for approximately ten minutes. When the stone absorbs the proper amount of water you will no longer see air bubbles floating to the top of the water. Place the whetstone on a flat, stable, slip-resistant surface coarse side facing up. Move the blade back and forth across the stone several times, tip to heel, at the correct angle for your knife. While sharpening, it is important to continuously pour water on the whetstone. Small particles release from the whetstone and form an abrasive substance when in contact with water. Repeat on the other side of the blade. Once this is complete, flip the stone over to the fine side and repeat the process. The fine side will take off any leftover steel. Finally, rinse the knives off in hot water.
Manufacturer contacted and sent a new one for replacement. Great customer service but replacement item was nicked on the corner. It was still usable so i didn't bother to ask for another replacement. I would recommend item to be shipped in another box instead of an over-sized yellow envelop which is not adequate protection. Item sharpen my knife pretty good though..
Four hundred million years ago in a small geographical region of Central Arkansas, now part of the Ouachita Mountains, nature began the creation of a sedimentary rock formation composed of microcrystalline quartz called Novaculite. The word Novaculite comes from the Latin word novacula, meaning razor stone. Novaculite is a recrystallized variety of chert. It is the stone material from which whetstone and oilstone sharpeners are made.
Not sure why I bought this item and then I received it. It has a bit of a 'cool' factor and is well made. I took the sharp edges of the stone as they were a bit uncomfortable on my chest but have since been wearing it a lot. Used it to put an edge on some workmates knives and to tickle up my own daily use knife. I like it, it is a bit different and useful.
A good whetstone and a little practice will keep all of your knives sharp and in perfect condition. The beauty is that it doesn’t take much effort to learn, just a good bit of practice to get the angle right and keep a consistent angle while you’re sharpening. Whetstones are available in department stores or online, and while they range in price based on the fineness of the grit, this thread at eGullet can help you pick a good grit to start with.
As opposed to water whetstones that require you to pre-soak the stone, the Norton oil stone is pre-filled with oil to save time and eliminate the need to pre-soak it prior to use and the lubricant stays on the surface during sharpening. The oil also prevents metal from bonding with the abrasive surface by flushing away dislodged abrasive and metal chips.
Our Whetstone Knife Sharpener Kit Comes With The Following: Double-sided premium quality 1000/6000 fine and super fine honing stone that sharpens and polishes A knife angle guide that keeps blades steady and at a perfect angle for sharpening A cleaning or laaping stone for the sharpening stone that keeps it in tip-top shape An aerated, non-slip, super slick, durable plastic protective box with breathing holes to keep product safe and dry A detailed instruction manual eBook with lots of tips and tricks suitable for every skill level
4. Start sharpening the first side of the blade. With your blade set at the prefect angle, you’re ready to start sharpening. Imagine you’re carving off a slim piece of the stone’s surface. Personally, I bring the blade into the stone. Other people stroke the blade away from the stone. Both ways work, so just use whatever technique you prefer. If the knife blade is curved or if it’s longer than the stone, you’ll need to sweep the blade sideways as you work, so the entire edge is sharpened evenly. Apply moderate pressure as you sharpen. No need to bear down hard on the blade. After you make one stroke, start back at the beginning and repeat. Do this about 6-12 times.
You need to adjust your fingers as you move the knife back and forth. Because sharpening takes place under your fingers, start with them at the tip and, as you pull the knife back toward you, release pressure completely and pause. Then, shift your fingers just a little down the blade toward the heel. This finger dance is critical and takes time getting used to.
Works well. Just got it today, sharpened two pocket knives, one a 8Cr13MoV Chinese steel, the other s30v American steel The stone made short work of both steels (which were pretty sharp already). But notably was able to make the s30v hair shaving sharp easily, something I've had trouble with. Inexpensive and useful, I love this stone. It's not the Ninja sharp 8000+ grits that you can find, but for pocket knives and EDC, it's perfect and inexpensive. Get One!!!!!!!!!!!!
Heres why I wasn't impressed at first. I only used it for a few minutes on each side, which resulted in nothing. I watched a video online with a master chef using his stone, and he sharpened his knife for 10 minutes on each stone before moving up to a finer grit. I took this hint, and used sharpened my knife on each side of this stone for 10 minutes, which led to perfection.
Once sufficiently wet, it's time to position the stone on something solid, so it doesn't move about during sharpening. Many come with holders, but you can just place it on a slightly damp tea towel on the table. The stone should be roughly perpendicular to your body, though Warner told me it is sometimes easier to angle it ever so slightly to the right (if you're right handed).