A great sharpener for all your kitchen knives the CS2 also makes a smart addition to the gear when you’re going away on a family camping trip. It will also do a bang-up job on your hunting, pocket, boning knife and more. As mentioned it does require just a bit of getting used to in order to achieve optimal results but nothing too involved. A simple, effective, no-frills sharpener.
To use Al's method, take a black felt pen and shade in the bevel of the knife. Then take two strokes on the stone and examine the edge. If you have maintained the proper angle then all the black will be gone. If you see black on the top of the edge it means you are holding the back of the knife too far from the stone. If there is black on the bottom of the edge but the top is clean then you are laying the knife too flat on the stone and you need to raise it a bit. Repaint the edge and try it again. Once you discover what the right angle looks like then just maintain that.
Seamlessly transition from the office to the gym with the Stuart & Lau Regimen Bag. The outer compartments are dedicated to work, with a tasteful blue nylon twill lining, padded laptop pouch, and various organizer pockets. In the center, you'll find the spacious 45L gym compartment, lined with a waterproof, wipe-down nylon. There's also a ventilated shoe pocket, interior and exterior water bottle slots, a rubberized base, and a built-in locker hook. Crafted from waterproof DuraLite fabric with full-grain leather trim and gunmetal hardware, it's built to last a lifetime — the same length as the S&L-backed warranty. Arrives with a leather key ring with a magnetic tab and a luggage tag with a detachable pen.
A shinkansen is a Japanese-style pull-through sharpener named after the famous bullet train. It features two sets of ceramic wheels set at the right angle for sharpening a Japanese blade, which takes out the guesswork of the waterstone. Simply hold the handle with your left hand, then saw back and forth gently through the coarser wheel to sharpen, before switching to the finer wheel to polish.
Freshly brewed beer tastes great, but nailing the brewing process is tough. The LG HomeBrew Beer Machine makes it easy. This countertop gadget uses single-use capsules containing malt, yeast, hop oil and flavoring and an optimized fermentation algorithm to let you brew beer with a single button press, creating up to five liters of suds every two weeks. Offered in the initial launch are a hoppy American IPA, American Pale Ale, full-bodied English Stout, Belgian-style Witbier, and Czech Pilsner. The machine will be on display at CES 2019, a perfect spot for finding thirsty test subjects.

Dull knives aren't just annoying — they can be downright dangerous. Keep yours in top shape with the Sharp Pebble Knife Sharpening Stone. It has a #1000 grit side for dealing with dull edges, and a #6000 side for honing to razor-like sharpness. It sits inside a silicone base, inside a non-slip bamboo base, and comes with an angle guide that slides over the spine, ensuring that even beginners can set a proper edge.

Functionality – If you have experience with the stick or sharpening stone you likely don’t want or need anything else. If, however, you are in search of an electric-powered sharpener you’ll want to consider how many “stages” you need in your sharpener. In a typical 3-stage sharpener the first stage is the coarsest and does most of the heavy lifting required to turn the edge from dull to sharp. The second stage will have finer grain sharpening wheels. These are used to hone the edge, that is, to smooth out the burrs left by the coarse first stage. A third stage will refine the edge even further and remove any debris left over from the sharpening process.

Some stones need water, while other stones need oil for floating the swarf (small metal filings created when sharpening) away. Simply apply a few drops of either oil or water directly to the stone. (We recommend using an inexpensive spray bottle for applying the water.) The lubricant you need is determined by the type of stone you are using. Water stones and diamond stones require water. Oil stones such as India, Crystolon and Arkansas stones use oil for a lubricant.
Diamond plates are available in various plate sizes (from credit card to bench plate size) and grades of grit. A coarser grit is used to remove larger amounts of metal more rapidly, such as when forming an edge or restoring a damaged edge. A finer grit is used to remove the scratches of larger grits and to refine an edge. There are two-sided plates with each side coated with a different grit.[14]
TO USE: Soak stone in water for no more than 5-10 minutes. Place stone on a damp cloth with the courser 400 grit side (dark green) facing up. Hold the knife so that it’s flat and perpendicular to the block, with the blade facing left. Holding the knife at a 20-degree angle, slowly sweep the edge of the blade from left to right down the length of the stone and continue until sharp. If stone starts to feel too dry, add more water. Be patient and take your time. Flip knife over and repeat on the other side (now moving from right to left). Be sure to sharpen both sides evenly. To polish the blade further, flip stone over to the fine 1000 grit side (light green) and repeat the process. When blade is honed to desired sharpness, wash and dry your knife. To clean your stone, simply rinse with water, wipe away any remaining metal residue with a rag, rinse again, then dry.
When the block is intended for installation on a bench it is called a bench stone. Small, portable stones (commonly made of bonded abrasive) are called pocket stones. Being smaller, they are more portable than bench stones but present difficulty in maintaining a consistent angle and pressure when drawing the stone along larger blades. However, they still can form a good edge. Frequently, fine grained pocket stones are used for honing, especially "in the field". Despite being a homophone with wet in most dialects of modern English, whetstones do not need to be lubricated with oil or water, although it is very common to do so. Lubrication aids the cutting action and carries swarf away.
Table mounted device – Typically the manual powered table mounted sharpener looks virtually identical to the electric powered sharpener with a slot for each stage. Where they differ is that each slot in the manual powered sharpener has only one groove and you pull the blade through this groove toward you to sharpen the blade. Once the blade is sufficiently sharp you place it in the honing groove to refine the edge and pull it toward you again several times. If there is a third, cleaning, stage you repeat the process for that stage as well.
✅ PREMIUM QUALITY : Our products have been inspected by a reputable third party inspection company. Each product has been checked,put under a durability and functionality test before shipped to you. NO COMPROMISE on quality! This simple-yet-unparalled award winning tool is used by everyone from stay at home moms to various professionals. Don’t forget to buy this as a PERFECT GIFT for your family & friends.

Pressure is something that is sometimes not mentioned but in my experience and in my opinion, it is extremely important to apply the correct amount of pressure, I use three different levels of sharpening pressure, with my sharpening pressure being measured on a scale from 1-5 with 1 being very light and 5 being maximum pressure. When you initiate the sharpening process, when you have all your ducks lined up and you are ready to start, use P4 (Pressure at level 4, almost maximum). in this case it is you and the stone working together, you are going to apply pressure with your finger tips (2 or 3 finger tips) placed as close to the primary edge as you can get, i.e. over the area you are working on, on the opposite side of the blade. As you push the knife away from you in a trailing motion, apply P4 pressure to the knife as it glides over the wet whetstone, (whet means sharpen) you will see the black residue start to form in the water on the surface, this is Swarf and this is good, don’t feel obliged to remove this with water, it is fine. Continue working from the heel to the tip of the knife moving your fingers along the edge and applying pressure as you move the knife away from you on the right side of the knife and as you pull it towards you on the left side, these are called edge trailing strokes.


My first set of sharpening stones so I have nothing to compare them to. For $50, though, great price to get into the world of sharpening. Stones are great and easy to use. Was able to put hair shaving edges on knives. Took a couple of knives to feel comfortable and better with the process and how to sharpen, but the stones you get work great. Here's the secret though. Get the green leather stoping block as well. As great as the stone are, I have found that stroping the knife after the fact is what really brings out that razor edge. And after using the knife, stroping it again, will restore and keep it razor sharp. Hope you enjoy it as much as I am.
This 600/1,000 grit is my second Unimi knife sharpener, the first is 2,000/6,000 grit and I love them both. Both stones together produce very sharp and well polished knives that reduce the cutting effort and save time in the kitchen. I particularly appreciate that the manufacture printed the grit number on the side of each stone - that helps use the different grits in the proper sequence from the coarser to the finer. The stone comes with a non-slip silicone/rubber base which is very handy.
×