You need a stone holder, something that can be purchased for as little as $20.00 to keep the water stone is place as you sharpen. A lot of water stones come with a base, so there’s so need to get it separately. Some people just have the stone on a piece of wood over a container of water with a cloth underneath the stone to keep it from slipping. The key is that you don’t need to spend a lot of money to get started and you don’t need Naniwa Chosera stones, you can start with King water stones if you like, those are fine and I don’t mention King in an attempt to say they are inferior in any way. The key to learning is not what you are using, not the quality or brand of stones, it is developing consistency with a technique that you can use comfortably and repeat. Saying that, stay away from the seven dollar stones available at the hardware store. (Remember, I tried everything).
Silicone Carbide whetstones on the other hand, are the fastest cutting of the three types of oil stones and the stones made by Norton are called Crystolon Stones. Also they too are graded as either fine, medium, or coarse stones depending on their grit. But, although these stones will not produce an edge as fine as Arkansas Oil Stones or India Oil Stones, their fast cutting ability makes them ideal for sharpening tools as well as for cutting the initial edge bevel on extremely dull knives or repairing the edge on damaged blades. Last, because they sharpen so quickly, it a common practice to start with a coarse Crystolon Oil Stone and then progress to either a medium or fine India Oil Stone and then to finish with an Arkansas Oil Stone.
Practice holding the knife at a 20 degree angle. Most straight blades need to be sharpened at a 20 degree angle. To find the angle, hold the directly in front of you so it's straight up and down. This is 90 degrees. Tilt the knife halfway towards the table so it's at a 45 degree angle. Tilt the knife halfway again so it's about an inch (2.5 cm) above the table. This should be a 20 degree angle.
There will be a drawer that extends into the mechanism under the abrasives. Any detritus from the sharpening process drops into this drawer. Exactly where the drawer is located will differ from sharpener to sharpener but it shouldn’t be hard to find. Remove the drawer flick any material into the wastebasket and then wipe out the drawer with a damp cloth or tissue. You may want to use work gloves and goggles to protect your hands and eyes from any loose metal shavings. Once the drawer is clean and dry replace it. The exact means by which the sharpening mechanism itself is cleaned will vary from manufacturer to manufacturer. Consult your owners guide for specific details. Make sure you don’t introduce any grease or other lubricants into the sharpener unless specifically directed to do so by the owner’s manual. Also, the outside of the sharpener should come perfectly clean with just a damp cloth. Avoid using commercial cleaners or abrasives of any kind.